MultiProfToParameterRef - Version 26.0

Last updated: 2026-01-06

This subassembly is used to target multiple profiles and has no coded points or links. The subassemblies elevation parameters can then be used as a parameter reference in another subassembly to define a parameter value. The elevations of the target profile used to define a slope must be set as a decimal slope. This subassembly may be used to tartget up to 6 different profiles as output values.

This subassembly is a single non-coded link, so it is attached at the selected point of another subassembly, or directly to the center assembly. When attaching directly to the center assembly, first specify which side of the assembly it will be constructed on, LEFT or RIGHT, in the subassembly properties. The MultiProfToParameterRef subassembly must be placed inside (or above in the assembly Construction Item list) of the subassembly that will be using the Parameter Reference.

In layout mode, this subassembly displays a non-coded link. The default input parameters assigned in this subassembly are the default values for the output parameters. These output parameters are used in a subassembly layout when assigned as a parameter reference value.

Info: All dimensions are in feet unless otherwise noted.

Parameter Description Type Default
Set Default Value - Target Control Profile 1 Used to assign slope or width value as a parameter reference from a target profile elevation Default Parameter 1.0
Set Default Value - Target Control Profile 2 Used to assign slope or width value as a parameter reference from a target profile elevation Default Parameter 1.0
Set Default Value - Target Control Profile 3 Used to assign slope or width value as a parameter reference from a target profile elevation Default Parameter 1.0
Set Default Value - Target Control Profile 4 Used to assign slope or width value as a parameter reference from a target profile elevation Default Parameter 1.0
Set Default Value - Target Control Profile 5 Used to assign slope or width value as a parameter reference from a target profile elevation Default Parameter 1.0
Set Default Value - Target Control Profile 6 Used to assign slope or width value as a parameter reference from a target profile elevation Default Parameter 1.0

This section lists the parameters in this subassembly that can be mapped to a profile target objects in a drawing.

Parameter Description Status
Target Profile 1 Only a profile can be used as targets for specifying a slope or a width. For Output
Target Profile 2 Only a profile can be used as targets for specifying a slope or a width. For Output
Target Profile 3 Only a profile can be used as targets for specifying a slope or a width. For Output
Target Profile 4 Only a profile can be used as targets for specifying a slope or a width. For Output
Target Profile 5 Only a profile can be used as targets for specifying a slope or a width. For Output
Target Profile 6 Only a profile can be used as targets for specifying a slope or a width. For Output

Parameter Description Type
Value 1 Target elevation as a slope. Slope Invert
Value 2 Target elevation as a slope. Slope Invert
Value 3 Target elevation as a slope. Slope Invert
Value 4 Target elevation as a slope. Slope Invert
Value 5 Target elevation as a slope. Slope Invert
Value 6 Target elevation as a slope. Slope Invert