Rural intersection: rename subassemblies

Total video time: 4:23

Last updated: 2026-01-06

Exercise files: rurl-int-cret-mnln-asmbly-cndtnl-01-begin-data-c3d16.zip

Start with: 12345678\Design\Corridors\Crdr-25-4thAve.dwg

rurl-int-renam-sub-01.mp4 4:23

Tip: It is critical to make sure all of the names of the subassemblies are correct. You can do it as you are building them or after the assembly is built. Be sure to label right or left side and what the assembly targets.

  1. LnExtendBase-R
  2. CondHorizTarget-TrnLn-NotFound-R
  3. CondHorizTarget-TrnLn-Found-R
  4. CondHorizTarget-IntCore-NotFound-R
  5. ShldGeneric-R
  6. LnExtendBase-TrnLn-R
  7. ShldGeneric-TrnLn-R
  8. DaylightProfileControlled-R

  9. DaylightProfileControlled-TrnLn-R

  10. Tip: If you label all of the subassemblies before you mirror them the names will follow them. Then you would only have to change each R to an L. These don't have to be labeled- labels are shown here for informational purposes.

  11. LnExtendBase-L
  12. CondHorizTarget-TrnLn-NotFound-L
  13. CondHorizTarget-TrnLn-Found-L
  14. CondHorizTarget-IntCore-NotFound-L
  15. ShldGeneric-L
  16. LnExtendBase-TrnLn-L
  17. ShldGeneric-TrnLn-L
  18. DaylightProfileControlled-L

  19. DaylightProfileControlled-TrnLn-L