Rural intersection: side road setup corridor

Total video time: 5:25

Last updated: 2020-10-26

Exercise files: rurl-int-crdr-edglin-ali-end-c3d16.zip

Start with: 12345678\Design\Corridors\Crdr-25-4thAve.dwg

rurl-int-creat-sdrd-setup-crdr-01.mp4 5:25

Comment: In the AliProf.dwg we made a Highway 25 setup corridor which will be used to tie down the curb and gutter elevation. We need another setup corridor to tie down the curb and gutter elevations for 4th Ave.

  1. Create the Assembly
    1. WisDOT Design tab > WisDOT & Civil Imperial palette > General tab
    2. Home tab > Create Design > Assembly > Create Assembly

    1. Place the Assembly off to the side
    2. MultiUseWidthAndSlopeLinks > Place on the assembly
    Right inside width20.000'
    Right inside SEUse outside lane SE
    Right outside width5.000'
    Right outside SEUse outside lane SE
    Left inside width20.000'
    Left inside SEUse outside lane SE
    Right outside width5.000'
    Right outside SEUse outside lane SE
    1. OK
  2. Home tab > Create Design > Corridor

  1. Set the Baseline and Region Parameters to the end of each taper

  2. Set the frequencies to 2.5'

  3. OK > OK > Rebuild Corridor
  4. Add Sections at the back of curb
  5. Create corridor surface > adjust the name > No Display > Top code > Add as a breakline > OK
  6. In the corridor change the code set to No Display and the feature lines to No Display