Edit design profile

Endpoint grip point

1. Select CthE profile.
2. Left-click the grip point at the end of CtE.
3. Shift right-click.
4. Select Endpoint.
5. Snap the end point snap to the end of the CthE-Exist profile.

Midpoint grip point

1. Select the square grip point in the middle of the last slope of the CthE profile.
2. Move the grip point.
3. Esc

Curve length grip points

1. Select the circular grip point at the beginning of the last curve.
2. Drag it to the right to shorten the length of the curve.

Curve radius grip point

1. Select the circular grip point in the middle of the last curve.
2. Move the grip point up and down to graphically change the radius of the curve.
3. Esc

PVI grip points

PVI adjusting incoming and outgoing slopes

1. Grab the triangle grip point that points straight up.
2. Move it up and down, left and right to move the PVI point.
3. Esc.

PVI maintain one slope

1. Select the triangular grip point that points to the right.
2. Move the grip point left and right to adjust the PVI while holding the incoming tangent.
3. Esc

prfl-edit-dsn-02.mp4 2:21

1. Select the CthE profile.

2. Context ribbon > Modify panel > Geometry Editor.

   

   

3. Insert PVI.

   

4. Click near the middle slope line.

5. Delete PVI points.

   

6. Click near the PVI point that was just added.

7. Move PVI.

   

8. Select near the sag curve PVI point.
9. Left-click a new point to the right of the original PVI location.
10. Esc to end command.

prfl-edit-dsn-03.mp4 1:09

1. Select the CthE profile.

2. Context ribbon > Modify Profile > Geometry Editor

   

3. Select the Delete Entity icon.

   

4. Select the last tangent line.
5. Left-click on the curve attached to the last tangent line.

6. In the toolbar select the Undo icon.

   

 

In the toolbar select Profile Grid View

In the third entity row make the following changes:

Variable	Value
Station	2097
Elevation	895
Grade In	-2.5
Grade Out	3
Profile Curve Length	500
K Value	90
Curve radius	8000

Click the X in the title bar to close the Profile Grid View panorama.

prfl-edit-dsn-05.mp4 2:13

Select the Select PVI icon.

Select near the PVI at the sag curve.

In the dialog make the following changes:

Variable	Value
Grade In	-2.5
Grade Out	3
PVI Station	2079
PVI Elevation	899
Profile Curve Length	400
Low Point Elevation	902
Curve radius	1500
K Value	74

Click the X in the upper right of the dialog.

Esc