Traffic signal plan sheet and phasing

Last updated: 2026-01-06

Example sheets: 024201-sp.pdf, 024301-ph.pdf
  1. Start a new file using the design-start.dwt.
  2. Save file as <proj num>/Sheets Plan/024201-sp.dwg
  3. WisDOT Sheets ribbon > Support panel > Palettes ON/OFF
  4. WisDOT Sheets > Sheet Creation panel > Sheets Layout
  5. Sheets Layout tab > 02-Plan Details 1=40 (02-PD-wdot)
  6. At command line type 01 ENTER
  7. WisDOT Sheets > Sheet Creation panel > Sheets Layout drop-down > Lighting and Signals
  8. Lighting and Signal tool palette > Traffic Signal Plan tab > Blocks – Signal Legend & Title Blocks area
  9. Select Title Block – Signal Page 1 – 3 Lines.
    1. In paperspace snap to the lower right corner of drafting area.
    2. Fill in Attributes dialog with appropriate data.
  1. Create viewport for view of model space.
  2. Add north arrow and rotate appropriately.
  3. Add blocks from Traffic Signal Plan tool palette to model area.
  4. Add Legend – Signal Plan block from Traffic Signal tool palette to sheet
  5. Add other blocks and annotation as needed.
  1. WisDOT Sheets ribbon > Support panel > Palettes ON/OFF
  2. WisDOT Sheets > Sheet Creation panel > Sheets Layout drop-down > Lighting and Signals
  3. Lighting and Signal tool palette > Traffic Signal Phasing tab > Sheet Layouts area > Phasing Sheet Layout
    1. At command line type SEQUENCE ENTER
  4. Traffic Signal Phasing tab > Signature Blocks area select Title Block – Signal PG2 – 3 Lines
    1. In paperspace snap to the lower right corner of drafting area.
    2. Fill in Attributes dialog with appropriate data. OK
  1. Add table blocks from Traffic Signal Phasing tool palette > Dynamic Tables
    1. These table blocks are dynamic with visibility states for different selection combinations. Select the down-arrow dynamic grip to choose the marked combinations.
  2. Add tables from Traffic Signal Phasing tool palette > Other Tables
    1. Add and change data in these tables through Block Editor.
    2. Add dynamic blocks from Traffic Signal Phasing tool palette > Phasing Table Dynamic Components to the tables while in the Block Editor.
    3. Add text, blocks, and manually created tables as needed.